- First and foremost, you must ensure that your cam or wheel is initially placed in a proper vertical position. This is accomplished by aligning a straight edge to the top cam of your machine. A straight parallel arrow is ideal for doing this check – I wouldn’t recommend using a bent arrow or a barreled shaft for this since it will throw you off your target.
Do you check cam lean at full draw?
What should I do if I have cam lean? Cam lean should only be changed by a technician who has been authorized and educated. Shooting a bow with significant cam lean may result in string derailment and possible damage…………………….. As an archer, you must realize that your bow’s cams will not be exactly straight in both the brace and full draw positions, regardless of your technique.
Does changing draw weight affect timing?
Changing the draw weight is a good technique to fine-tune your shot for specific left/right tearing. If you decide to adjust the draw weight, you’ll have to retune (it could potentially affect cam lean and timing as well). Before going hunting, at the very least, double-check your broadheads.
Does cam lean affect accuracy?
Moderate cam lean (also known as “normal”) will have no effect on accuracy when using field points. Accuracy is all about consistency, and cam lean is a reliable source of constancy.
How do I check my cam timing?
Take the intake valve as a starting point and slowly turn the crank clockwise until the lifter rises 0.050 inch. Stop rotating the crank and turn the degree wheel to find out what the temperature is. The duration of this begins at 0.050 inch. If our cam card indicates that the intake valve opens at 31 degrees BTDC, the degree wheel should also indicate that the intake valve opens at 31 degrees BTDC at this moment.
What is yoke tuning a bow?
Yoke tuning is the process of adjusting the control cable at the point where it divides or becomes a “yoke” in order to provide a smooth path of movement for the string. When the yoke is properly tuned, the bowstring will track straight off the idler wheel at full draw, without swerving to the right or left.
Can you swap cams on a bow?
Much more may be accomplished with a PSE bow than simply swapping out one kind of PSE cam for another brand of PSE cam on the same bow. Make a Mathews SINGLE cam bow, throw on some Hoyt Spirals, and you’ve got yourself the ONE and ONLY unholy marriage between Hoyt and Mathews in the history of the world.
What is a cam on a compound bow?
Much more may be accomplished with a PSE bow than simply swapping out one kind of PSE cam for another brand of PSE cam. Make a Mathews SINGLE cam bow, throw on some Hoyt Spirals, and you’ve got yourself the ONE and ONLY unholy marriage between Hoyt and Mathews in the whole history of the world!
Is 70 lb draw too much?
The holding weight of an archery bow with a peak weight of 70 pounds and a let-off of 80 percent, for example, should be around 14 pounds. A bow at full draw for 30 seconds is impressive, but if you’re shaking, straining, and weary at the end of that time, you won’t be able to make a legal shot in most situations.
How do I know when to increase draw weight?
The short answer is that it is time for an archer to raise their draw weight when they do any of the following:
- Your muscles have the ability to comfortably fire your bow for an extended period of time without becoming fatigued. For example, you need to fire farther distances than your present draw weight permits, or… Unfortunately, your arrows are continuously falling short of the mark.
How do you turn up the pound on a bow?
It is necessary to unload or load extra stress (flex) on the limbs in order to alter the draw weight. This is accomplished by tightening or loosening the limb bolts, respectively. If you want to raise the draw weight to its maximum poundage, tighten the limb bolts (in the clockwise direction) until all limbs are snug against the riser.