- To get an accurate measurement, place one end of the square against one of the higher limbs where it intersects the riser’s top and measure with a string. Repeat the process with the lower limb. On most compound bows, the distance between the top and bottom tillers should be equal or no more than a quarter-inch difference (check your unique bow’s specs).
How does a bow square work?
Bow square in the shape of a T. The square connects to the string above and below the nocking point on both sides. Brace height and nock position are to be measured using this tool.
Do you need a bow Square?
It is critical to set up your nocking point when putting up a new bow for the first time, and this is one of the most crucial things you can do. If you want to make consistent shots with your bow, this indication will assist you to know exactly where to nock your arrow onto your bowstring each time. You’ll need to utilize a tool known as a bow square to do this.
Where do you put the Nocking point?
It is critical to set up your nocking point while putting up a new bow for the first time, and this is one of the most difficult tasks you will face. If you want to make consistent shots with your bow, this indication will assist you to know exactly where to nock your arrow onto your bowstring every time. An instrument known as a bow square will be required for this.
What is a Berger hole on a bow?
On a compound bow, the Berger Hole is the tapped hole that is located above the arrow shelf. From the exterior of the riser, the arrow rest is screwed into the berger hole to hold it in place. When setting up your bow, it is customary to have your arrow centered on the center of the berger hole on the arrow rest.