- Take a tape measure and measure yourself while holding your arms out to your sides. Then have someone measure the distance between the tips of your middle finger and the other middle finger (you know, the finger you use to “point” when someone cuts you off in traffic). Take that number and divide it by 2.5 to get a good idea of how long your draw length should be.
How do you adjust the draw length on a diamond carbon cure?
Diamond bows include a universal draw length adjustment feature that does not require the use of draw length specific modules. This functionality is made feasible thanks to the Rotating Mod System. Your draw length may be modified by simply rotating the module clockwise or counterclockwise. Typically, 1/2 inch increments are used to alter the draw length.
How do you determine your draw length?
Place your back against a wall and stretch both of your arms out against the wall to determine the length of your draw length. Simply measure the distance between the ends of your middle fingers on both arms, hands, and chest. This is the length of both arms, hands, and chest. Your draw length is calculated by subtracting 15 from this measurement and dividing the result by two.
How much does it cost to adjust draw length on a bow?
The swapping out of the modules is commonly accomplished with a hexagonal wrench and may be accomplished without pushing the compound bow button. While some firms will allow lifetime module changes, the majority of new modules must be purchased separately. The average cost ranges from $8 to $25.
How do you adjust the draw length on a Diamond Razor Edge?
The draw length may be increased by unscrewing the module’s mod screws and rotating it counter-clockwise (when looking at the bottom cam; reverse if looking at the higher cam). The “29” setting always corresponds to the longest draw length that may be achieved. Replace the screws once you’ve rotated the module to the proper spot on the board.
How far can you back out limb bolts?
What is the maximum distance I can back my limb bolts out and how many pounds of draw weight do I lose with each turn? The maximum number of spins that you can make with your limb bolts on most Hoyt bows is eight on most models (8).
Does changing draw length affect sights?
The peep will be higher as a result of shortening the draw length, which will require you to tilt your bow upward in order to line the peep with the sight housing. You will be able to hit harder as a result of this. Despite the fact that the bow will be a little slower, you may still need to shift the peep down or sight up.
How do you adjust the draw length on a Mathews bow?
Rotate the adjustment wheels on the cam one mark up or one mark down to increase or reduce draw length, respectively. For example, if you want to reduce the present draw length of the bow by one inch and the cam is set to the mark “C” or the mark “3,” twist the wheel until the mark “B” or the mark “2” appears on the cam.
How do you adjust the draw length on a Parker compound bow?
Locate the bolts that hold the bow limbs together. Both bow ends have these, which are distinguishable by their 3/16-inch Allen key screw-heads, and they are positioned immediately above the cams on both ends. Each bolt should be turned counter-clockwise with the Allen key in order to reduce the draw weight. Each complete turn of the screw results in a two- to three-pound reduction in weight.
How do I know if my draw length is too long?
The bow limb bolts should be located. Their 3/16-inch Allen key screw-heads distinguish them from the others, which are positioned at both bow ends just above the cams. Each bolt should be turned counter-clockwise with the Allen key in order to reduce the pull weight. Each complete turn of the screw results in a two- to three-pound reduction in weight.
Is arrow length and draw length the same?
Draw length – To put it simply, your draw length is the distance between your anchor point and the end of the bow string. This is measured in inches, thus my measurement is just less than 28 inches (27 1/2 inches if you want to be exact). Arrow length – The length of your arrow is the measurement of how long it is.