How To Use Archery T Bow Square?

  • To get an accurate measurement, place one end of the square against one of the higher limbs where it intersects the riser’s top and measure with a string. Repeat the process with the lower limb. On most compound bows, the distance between the top and bottom tillers should be equal or no more than a quarter-inch difference (check your unique bow’s specs).

How does a bow square work?

Bow square in the shape of a T. The square connects to the string above and below the nocking point on both sides. Brace height and nock position are to be measured using this tool.

Do you need a bow Square?

It is critical to set up your nocking point when putting up a new bow for the first time, and this is one of the most crucial things you can do. If you want to make consistent shots with your bow, this indication will assist you to know exactly where to nock your arrow onto your bowstring each time. You’ll need to utilize a tool known as a bow square to do this.

How do you find the Nocking point on a bow?

Most conventional bows prefer to have the nocking point roughly 1/2 inch above the shelf, according to our research. To begin, connect your nocking point 1/2 inch above the surface of the water. This indicates that the bottom of the brass nock is 1/2 inch higher than the arrow shelf at its highest point. This measurement is made simple with your T-Square.

What is Bowsight aiming method?

With bow sights, you align the proper sight pin on the target by aiming the bow at it. It is sufficient to just glance at the chosen target with both eyes open and release when using intuitive aiming.

See also:  What Is The Best Arrow For 3D Archery? (Solution)

Do you put the arrow above or below the nock?

As a result, when the arrow is DEAD LEVEL, the arrow nock at your corner of mouth anchor, the arrow nock is ABOVE the deepest point of the curve on the GRIP, and the arrow nock is at your corner of mouth anchor. Consequently, to prevent the arrow nock from sliding up the bowstring, the arrow nock is placed BELOW the nock point on the bowstring.

Leave a Comment

Your email address will not be published. Required fields are marked *